Olivetti PGL2545 Operation Manual page 158

DHCPv6 (DHCPv6 setting)
DHCPv6 is the next-generation of the Internet's Dynamic Host Configuration Protocol and supports IPv6. It extends the
BOOTP startup protocol that defines the protocols used for transferring configuration information to hosts on the network.
DHCPv6 permits the DHCP server to use its expanded functionality to send configuration parameters to an IPv6 node.
Because the network addresses that can be used are allocated automatically, the IPv6 node management workload is
reduced in systems where the administrator has to exercise close control over IP address allocation.
DHCPv6 Settings:
DHCPv6
01
02 IP Address
DHCPv6:
01 * Off
02 On
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used.
LAN Interface:
01 * Auto
02 10BASE-Half
10BASE-Full
03
1
In the IPv6 Setting menu, press  or  to select DHCPv6.
2
Press [OK]. The DHCPv6 menu screen appears.
3
Press  or  to select DHCPv6.
4
Press [OK]. The DHCPv6 screen appears.
5
Press  or  to select whether DHCPv6 is enabled.
6
Press [OK]. The DHCPv6 setting is set and the IPv6 Setting
menu reappears.
Note When On is set, IP addresses are shown in "IP
Address" after network restart.
1
In the Wired Netwk. Set menu, press  or  to select LAN
Interface.
2
Press [OK]. The LAN Interface screen appears.
The available LAN Interface are as follows:
Auto
10BASE-Half
10BASE-Full
100BASE-Half
100BASE-Full
1000BASE-T
3
Press  or  to select the desired LAN Interface.
4
Press [OK]. The LAN Interface is set and the Wired Netwk. Set
menu reappears.
4-77
Operation Panel