Foot Switch - Genie Z-25/8 Service Manual

First Edition • Third Printing
Drive controller specifications
Drive
Threshold, all models
Max out
(when joystick is in full forward position)
Z-20/8N models
Z-20/8 and Z-25/8 models
Lo range
(when joystick is in full forward position)
Z-20/8N models
Z-20/8 and Z-25/8 models
Drive speeds
Z-20/8N models
Stowed position,
max out
40 ft/10.5 sec
Lo range
40 ft/20.9 sec
Boom raised
40 ft/40 sec
Z-20/8 & Z-25/8 models
Stowed position,
max out
40 ft/10.1 sec
Lo range
40 ft/19.5 sec
Boom raised
40 ft/40 sec
Part No. 41314
1.2V DC
4.7 to 4.8V DC
4.4 to 4.5V DC
2.02 to 2.12V DC
1.95 to 2.05V DC
2.6 mph 4.2 km/h
12.2 m/10.5 sec
1.3 mph 2.1 km/h
12.2 m/20.9 sec
0.6 mph 1 km/h
40 ft/40 sec
2.7 mph 4.3 km/h
12.2 m/10.1 sec
1.4mph 2.3 km/h
12.2 m/19.5 sec
0.6 mph 1 km/h
40 ft/40 sec
Genie Z-20/8N & Genie Z-20/8 & Genie Z-25/8
Section 7 • Repair Procedures
1-2

Foot Switch

How to Test the Foot Switch
1 Turn the key switch to the
separate the wiring quick disconnect plug from
the platform toe board.
2 Do not press down the foot switch. Connect the
leads from an ohmmeter or continuity tester to
the wire combination listed below and check for
continuity.
Test
red to black
red to white
black to white
PLATFORM CONTROLS
position and
OFF
Desired result
continuity
(zero W)
no continuity
(infinite W)
no continuity
(infinite W)
7 - 5