Attaching The Slide Members To The Rack - IBM 4560SLX User Manual

Attaching the slide members to the rack

To attach the slide members to the rack, complete the following procedure:
1. Attach the front (shorter) and rear (longer) mounting brackets to the outer and
1
Front mounting bracket
2
Rear mounting bracket
3
Middle slide member
Figure 12. Installing the slide members
2. Depending on the type of rack you are installing, use the clip or cage nuts to
1
Clip or cage nuts
2
Vertical member mounting holes
3
Middle slide member
Figure 13. Installing slide member fasteners
middle slide members as shown in Figure 12.
IMPORTANT: Fully tighten the front mounting bracket screws. Leave the rear
mounting bracket screws "finger tight" to prevent binding when mounting the
library module. Once the distance between rails is set, the screws should be
fully tightened.
attach the slide member assembly to the rack as shown in Figure 13.
Get other manuals https://www.bkmanuals.com
13
Chapter 2. Installation