Installing The Cartridge Elevator - IBM 4560SLX User Manual

Figure 65. Cartridge elevator router installed

Installing the cartridge elevator

To install the cartridge elevator, complete the following procedure:
Note: The following procedure assumes that the modules have been prepared for
1. Ensure that the router is mounted at the top of the rack.
2. If modules are rack-mounted, verify that all units are powered down and the
3. Remove drive shoe 2 as shown in Figure 66 on page 73 or the blank cover for
72
4560SLX Tape Library: User's Guide
rack-mount installation or are installed in a rack.
power cords are removed.
Note: Attempting to install the cartridge elevator to a fully powered 4560SLX
Tape Library module might cause severe damage to unit circuitry.
each module that will use the cartridge elevator.
Get other manuals https://www.bkmanuals.com