Figure 44. Installing the riser card in riser 2
Next steps
1. If applicable, connect the cable to the riser card.
2.
Install the expansion card riser 1
3. Follow the procedure listed in
M.2 SSD module
Removing the M.2 riser
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
Steps
1. Using a Phillips 1 screwdriver, remove the screw that secures the riser to the chassis.
2. Holding the blue tag, lift the riser to disengage the riser from the connector on the system board.
and
install the expansion card riser
After working inside your
Safety
instructions.
Before working inside your
2.
system.
system.
Installing and removing system components
71