Table of Contents
Advertisement
NOTE:
Press the retention frame while tightening the screws to avoid tilting of the processor cover out of the
processor socket.
Figure 58. Securing the retention frame
Next steps
1.
Install the heat
sink.
2.
Install the air
shroud.
3. Follow the procedure listed in
Installing the heat sink
Prerequisites
Never remove the heat sink from a processor unless you intend to replace the processor or system board. The heat sink is
necessary to maintain proper thermal conditions.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the air
shroud.
4. If installed, remove the processor dust cover.
Steps
1. If you are using an existing heat sink, remove the thermal grease on the heat sink by using a clean lint-free cloth.
NOTE:
For a new heat sink, the thermal paste is pre-applied to the heat sink. Remove the protective cover, and install
the heat sink.
2. Apply thermal grease in a thin spiral on the top of the processor.
84
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Advertisement
Table of Contents
