Figure 61. Removing the Power Interposer Board
Next steps
1.
Replace the Power Interposer
Installing the Power Interposer Board
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
4.
Remove the support bracket
Steps
1. Align the guide hole of the Power Interposer Board (PIB) with the T-shaped pin on the sled.
2. Align the power interposer board and using the blue holder, slide the PIB into the slot on the system board.
3. Using a Phillips 2 screwdriver, tighten the screws that secure the PIB on the sled.
Board.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
87