Support Bracket; Removing The Support Bracket - Dell PowerEdge C6615 Installation And Service Manual

Steps
1. Align the air shroud hooks with the link bar on the sled.
NOTE: Ensure that the SATA cables are routed behind the air shroud clip.
2. Lower the air shroud until the snap clips on the right and left side of the shroud lock into the base of the sled.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
Figure 23. Installing the air shroud
Next steps
Follow the procedure listed in

Support bracket

Removing the support bracket

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud.
Steps
1. Using the Phillips 1 screwdriver, remove the screws that secure the support bracket to the chassis.
52 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
system.
system.