Table 50. Configuration 2: R1A+R2C (continued)
Card type
Marvell HBA: FC32
Marvell HBA: FC32
Mellanox NIC: N400
Mellanox NIC: NDRV
Mellanox NIC: N200
Mellanox NIC: H100
Mellanox NIC: 25Gb
Broadcom OCP: 25Gb
Mellanox NIC: 100Gb
Foxconn PERC Adapter
Foxconn PERC Adapter
Foxconn PERC Adapter
Foxconn PERC Adapter
Removing the expansion card riser 1
Prerequisites
NOTE:
Install an expansion card filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the system and aid in proper
cooling and airflow inside the system.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in the
3. If applicable disconnect the cables.
Steps
1. Using a Phillips 1 screwdriver, remove the screws that secure the expansion card riser 1.
2. Holding the handle, lift the expansion card riser from the riser connector on the system board.
Slot priority
1,2
1,2
1,2
1,2
1,2
1,2
1,2
Integrated Slot
1,2
1
1
1
1
Safety
instructions.
Before working inside your
Maximum number of cards
2
2
2
2
2
2
2
1
2
1
1
1
1
system.
Installing and removing system components
59