Figure 60. Installing the heat sink
Next steps
1.
Replace the air
shroud.
2. Follow the procedure listed in the
Power Interposer Board
Removing the Power Interposer Board
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
4.
Remove the support bracket
Steps
1. Using a Phillips 2 screwdriver, remove the screws that secure the Power Interposer Board (PIB) from the sled.
2. Using the blue holder, slide out the PIB from the slot to remove it from the system.
86
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
system.
system.