Table of Contents
Advertisement
Checking that your oven is operating correctly
The following simple procedure enables you to check that your oven is
working correctly at all times. If you are in doubt, refer to the section entitled
"Troubleshooting" on the page 95-98.
NOTE
The oven must be plugged into an appropriate wall socket. The turntable must be
in position in the oven. If a power level other than the maximum (100 % - 900 W)
is used, the water takes longer to boil.
NOTE
When power is supplied and whenever you are not using the microwave oven, "0"
is displayed on the display.
Open the oven door by pulling the handle on the upper side of the door.
Place a glass of water on the turntable. Close the door.
Press the START/+30s button and set the
time to 4 or 5 minutes, by pressing the
START/+30s button the appropriate number
of times.
Result: The oven heats the water for 4 or
5 minutes. The water should then
be boiling.
Cooking/Reheating
The following procedure explains how to cook or reheat food.
IMPORTANT
ALWAYS check your cooking settings before leaving the oven unattended.
Open the door. Place the food in the centre of the turntable. Close the door. Never
switch the microwave oven on when it is empty.
1
2
3
4
1.
Press the Microwave button.
Result:
The following indications are
displayed:
(microwave mode)
2.
Set the cooking time by turning the
Multi Function Selector Dial.
The cooking time is
Result:
displayed. At that time, press
the Multi Function Selector
Dial to set the cooking time.
Set the power level by turning the
3.
Multi Function Selector Dial until the
appropriate power level is displayed.
4.
Press the START/+30s button.
Result:
The oven light comes on and
the turntable starts rotating.
Cooking starts. When it has
finished.
1)
The oven beeps 4 times.
2)
The end reminder signal will beep
3 times (once every minute).
3)
Display shows "0".
English 13
Advertisement
Table of Contents
