Table of Contents
Advertisement
Installation
Maintenance
Installation site
20 cm
above
10 cm behind
10 cm
10 cm
on the
on the
85 cm of the
85 cm of the
side
side
floor
floor
Turntable
10 English
•
Select a flat, level surface approx.
85 cm above the floor. The surface
must support the weight of the oven.
•
Secure room for ventilation, at least
10 cm from the rear wall and both
sides, and 20 cm from above.
•
Do not install the oven in hot or damp
surroundings, such as next to other
microwave ovens or radiators.
•
Conform to the power supply
specifications of this oven. Use only
approved extension cables if you need
to use.
Wipe the interior and the door seal
•
with a damp cloth before using your
oven for the first time.
Remove all packing materials inside the
oven. Install the roller ring and turntable.
Check that the turntable rotates freely.
Maintenance
Cleaning
Clean the oven regularly to prevent impurities from building up on or inside the
oven. Also pay special attention to the door, door sealing, and turntable and roller
ring (applicable models only).
If the door won't open or close smoothly, first check if the door seals have built up
impurities. Use a soft cloth in soapy water to clean both the inner and outer sides
of the oven. Rinse and dry well.
To remove stubborn impurities with bad smells from inside the oven
1.
With an empty oven, put a cup of diluted lemon juice on the centre of the
turntable.
2.
Heat the oven for 10 minutes at max power.
3.
When the cycle is complete, wait until the oven cools down. Then, open the
door and clean the cooking chamber.
To clean inside swing-heater models
CAUTION
•
Keep the door and door sealing clean and ensure the door opens and closes
smoothly. Otherwise, the oven's lifecycle may be shortened.
•
Take caution not to spill water into the oven vents.
•
Do not use any abrasive or chemical substances for cleaning.
•
After each use of the oven, use a mild detergent to clean the cooking chamber
after waiting for the oven to cool down.
To clean the upper area of the cooking
chamber, lower the top heating element by
45° as shown. This will help clean the upper
area. When done, reposition the top heating
element.
Advertisement
Table of Contents
