Cursor Position Reference Mark; Auto Train - Furuno FSV-25 Operator's Manual

3.3.3

Cursor position reference mark

The cursor position reference mark, a solid circle, is inscribed on the vertical bearing
mark when the cursor is placed in the vertical display. Its purpose is to show corre-
sponding cursor position on the horizontal display. It changes position with cursor po-
sition, tilt and range, and disappears when its position is no longer within the range of
the horizontal display.
Cursor position
reference mark
3.4

Auto Train

You may scan the vertical bearing mark in the sector of ±12°, ±24° and ±36°. Press
and hold down the AUTO TRAIN key while pressing the V1/S or V2 key to select the
auto train sector desired. Selected sector appears in large characters for five seconds
for your confirmation. To cancel auto train, repeat the above procedure to select
[OFF].
Note: If both the auto train and the target lock are active in a vertical mode, the follow-
ing restrictions apply:
• V1 mode: Auto train is disabled.
• V2 mode: The auto train for the vertical bearing marker is disabled.
Disable the target lock to restore the auto train.
V
Vertical
bearing
mark
Cursor
Auto train mark
Auto train sector
1
Vertical bearing mark
3. VERTICAL MODE
VERTICAL
DISPLAY
Tilt mark
3-5