Maintenance Menu; Changing The Maintenance Menu - Ricoh AP900 Software Manual

Making Printer Settings Using the Control Panel

Maintenance Menu

You can set printing conditions such as density and calibration, and printer man-
agement such as formatting the optional hard disk unit.

Changing the maintenance menu

This section explains changing the maintenance menu using examples.
HD Format
Follow the procedure below to format the hard disk unit after initial setup.
A
Press the {Menu} key.
The [Menu] screen appears.
B
Press the {T} or {U} key to display [Maintenance], and then press the {#
Enter} key.
C
Press the {T} or {U} key to display [HD Format], and then press the {# En-
ter} key.
D
Read the HD format confirmation message, and then press the {# Enter}
key to start formatting.
The hard disk unit is formatted, and the rebooting message appears.
E
Turn off the printer's power. After a few seconds, turn the power on
again.
The hard disk unit is now formatted and ready to use.
Displaying the signal strength
Follow the procedure below to check the IEEE 802.11b (wireless LAN) signal on
the [Maintenance] menu.
145