Spool Printing - Ricoh AP900 Software Manual

Other Print Operations
❒ If you cannot make punch settings even with the finisher installed, options
may not be set correctly in the printer driver. Correct option settings in the
printer driver. For details, see the printer driver Help.
❒ When duplex printing is selected, adjust punch positions according to binding
orientation.
❒ Be sure to set the punch position the same as the staple position when using
it with the staple function.
❒ Be sure to set paper size and orientation in the printer driver when punching.
• Depending on the software you are using, print settings may not be ena-
bled and the printed result may not be as expected.
❒ Punch will be canceled under the following conditions:
• When a paper size that cannot be punched is selected. For information
about paper sizes that can be punched, see "Specifications", Maintenane
Guide.
• If positions other than those fixed for punching are specified.
• If there are inconsistencies between the orientation in duplex mode and the
punch position.
• When feeding paper from the bypass tray.
• When the punch receptacle has become full and Auto Continue is set,
printing will continue without punching after the message appears.

Spool Printing

With Spool Printing, the print data is saved in the hard disk before printing. To
use this function, set it from the menu. See
❒ Do not turn off the printer or the computer when a print job is being spooled
and the Data In indicator is blinking. The print job will remain in the hard disk
and be printed when the printer is turned on. The setting can be changed us-
ing the "spoolsw clear job" command on the telnet
❒ The Spool Printing function is available for data received using diprint, lpr, ipp,
ftp, and smb.
❒ When using diprint, the Spool Printing function cannot be used with bidirec-
tional communication.
❒ The domain reserved for spool printing is about 2 GB.
❒ When Spool Printing is on, the size of a single print job cannot exceed 500
MB.
p.150 "System
Menu".
122