D-Link NUCLIAS DNH-100 User Manual page 66

Nuclias Connect Software User Manual
Nuclias Connect
IPv4 ACL
The IPv4 ACL (Access Control List) feature for the switch can help improve network performance and security by blocking se-
lected traffic. Navigate to Configuration > Profile Settings > Site > Network > Switch > Your Device > IPv4 ACL to config-
ure the settings.
In the User defined IPv4 ACL Rules section, the following fields are presented:
Field
Sequence No.
Policy
Source
Destination
Comment
Protocol
Src Port
Dst Port
Once complete, click Add to add the rule, or Clear to clear all values.
In the IPv4 ACL Rule Table section, a summary of all IPv4 ACL Rule is displayed. Under the Action field, click Edit to edit the
ACL rule; Click Delete to delete the ACL rule. Click Save to save the changes.
Configuration Profile Settings
Description
Set the sequence number. The range is 1-65535.
Select Auto to auto-assign the sequence number
Select to permit or deny what traffic goes through the
switch.
Enter the source IP address. When the Protocol is set to
Any, all traffic destination will be evaluated.
Enter the destination IP address. When the destination
is set to Any, all traffic destination will be evaluated.
Enter a description for the rule.
Select between TCP, UDP, or Any.
Specify the number of the source port. The valid value
is 0-65535. When the Src Port is set to Any, all traffic
source will be evaluated.
Specify the number of the destination port. The valid
value is 0-65535. When the Dst Port is set to Any, all
traffic source will be evaluated.
Page 66
Nuclias Connect Configuration
Switch