D-Link NUCLIAS DNH-100 User Manual page 52

Nuclias Connect Software User Manual
Nuclias Connect
2.4GHz/5GHz/5GHz 2 (Tri-Band)
The Performance page allows you to configure the wireless performance for access points on your network. Additionally
advanced wireless settings can be configured on the page for both the 2.4GHz and 5GHz frequency bands. Navigate to
Configuration > Profile Settings > [Site] > [Network] > Device Setting to view existing settings. Click the 2.4GHz or 5GHz tab
to view existing settings.
Parameter
Wireless
Wireless Mode
Data Rate
Beacon Interval
DTIM Interval (1-15)
WMM (Wi-Fi Multimedia)
ACK Timeout
Short GI
IGMP Snooping
Multicast Rate
Multicast Bandwidth
Control
Maximum Multicast
Bandwidth
HT20/40 Coexistence
Change DHCPOFFER
from Multicast to Unicast
RTS Length (256-2346)
Fragment Length (256-
2346)
Channel Width
Click Save to save the values.
Configuration Profile Settings Access Point
Description
Click the drop-down menu to turn on or off the wireless band for
the network.
Click the drop-down menu to select the wireless mode used in the
network.
Click the drop-down menu to select the wireless data rate. The
function is only available when Wireless Mode is Mixed 802.11g
and 802.11b (2.4GHz) or 802.11a Only (5GHz).
Enter the beacon interval value. The default value is 100.
Enter the DTIM interval value. The default value is 1.
Click the drop-down menu to enable or disable the Wi-Fi Multimedia
(WMM) function.
Enter the ACK timeout value. The default value is 48.
Click the drop-down menu to enable or disable the short GI
function.
Click the drop-down menu to enable or disable the IGMP snooping
function.
Click the drop-down menu to select the multicast rate value.
Click the drop-down menu to enable or disable the multicast
bandwidth control function.
Enter the maximum multicast bandwidth value. The default value
is 100. The function is only available when Multicast Bandwidth
Control is Enabled.
Click the drop-down menu to enable or disable the HT20/40
coexistence function.
Click the drop-down menu to allow or deny the transfer of DHCP
offers to unicast function.
Enter the RTS length value. The default value is 2346.
Enter the fragment length value. The default value is 2346.
Click the drop-down menu to select the channel width used by the
network.
Page 52
Nuclias Connect Configuration
Performance