D-Link NUCLIAS DNH-100 User Manual page 57

Nuclias Connect Software User Manual
Nuclias
Wireless Resource 2.4GHz/5GHz-1/5GHz-2 (Tri-Band)
The Wireless Resource function in Nuclias Connect helps provide real-time RF management of the wireless network. Navigate
to Configuration > Profile Settings > [Site] > [Network] > Wireless Resource. Click the 2.4GHz or 5GHz tab to view existing
settings.
Parameter
ACL RSSI
Threshold
Aging Out
Aging Out
RSSI Threshold
Data Rate
Connection Limit
User Limit (0~64)
11n Preferred
Network
Utilization
Click Save to save the values and update the screen.
Once the settings are updated, the configuration must be uploaded to the access points. See "Profile Settings" on page 41 for
further information.
Configuration
Description
Check the box to enable ACL RSSI threshold function and click the
drop-down menu to select the ACL RSSI threshold percentage.
Use the drop-down menu to select criteria to disconnect wireless
clients. Available options are RSSI and Data Rate.
Click the drop-down menu to select the aging out mode
When RSSI is selected in the Aging out drop-down menu, select
a value between 10% to 100%. This parameter sets the minimum
RRSI for a wireless clients to respond to a probe. If the determined
value is lower than the specified percentage, the wireless client is
disconnected.
Click the drop-down menu to select the data rate connection
limit. The function is only available when the Aging Out policy is
set to Data Rate.
Click the radio button to enable or disable the function. Connection
limit is designed to provide load balancing. This policy allows user
access management on the wireless network. The exact number
is entered in the User Limit field below. If this function is enabled
and when the number of users exceeds this value, or the network
utilization exceeds the specified percentage, the policy will not
allow further client association.
Enter the user connection limit. The default value is 20.
Click the drop-down menu to enable or disable the preferred use
of 802.11n.
Click the drop-down menu to select the network utilization
percentage.
Profile Settings
Page 57
Nuclias Connect Configuration
Access Point