Table of Contents
Advertisement
64
Optional Equipment
Installation
1
Remove the grill from the manifold (2 screws hold it in place).
2
Remove the rear-mounting brackets by loosening 1/4" screws and sliding it out of the keyhole
slots.
3
Determine the desired location of the bottom of the convection air outlet. Install a horizontal
framing member at the desired height, parallel to the header. Install a second horizontal framing
member 3-3/4" above the first. These two framing members will support the upper convection
manifold in the following steps.
4
Hold the upper convection manifold with the outlet facing the back of the framing members
installed in the previous step. Tilt the outlet of the manifold downward until the outlet of the
manifold and the two mounting tabs can fit between to two framing members. Slide the outlet into
the gap and allow it to sit level again. The two mounting tabs will support the manifold.
© Travis Industries
(for qualified installers only)
Mounting
tabs
5/8/2019 - 1505
564 GSR2 25K CF
Advertisement
Table of Contents
