Advertisement
Tools Required
Philips Screwdriver
Installation Notes
WARNINGS:
Make sure the gas control valve is OFF and the heater is cool prior to conducting service.
Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved
with this appliance may result in property damage or personal injury.
HINTS:
The fireplace should be in place, with the gas line and vent attached and the firebacks installed (see owner's
manual for further details).
If using propane (LP), convert the appliance before installing the logs (see the owner's manual for details).
Mounting Hardware Installation
Remove the glass frame assembly to gain access to the firebox (see manual for details).
The map below shows the location of each of the log locating plates and stone locating tabs
in relation to the media tray. Look in the approximate location indicated and you will notice
holes that are slightly smaller than the others (see picture below – these holes are hard to
find – use a flashlight if necessary). These smaller holes receive the screws that secure the
tab/plate to the media tray.
Attach the appropriate tab/plate to the media tray using the included screws. Make sure the
tab/plate is facing the correct direction. Do not over-tighten the screws.
KEY
L = Log Placement plate.
#xx tabs refer to the number stamped on the stone tab (and corresponding stone).
The arrow (
) points to the bent up portion of the stone placement tab (see
illustration to the right).
L
L
L
Page 2 of 12
4415 HO ST - Driftwood Log Set
Installation Instructions
REAR OF FIREPLACE (Non-Service Side)
L
#13
#32
FRONT OF FIREPLACE (Service Side)
#10
17602107
— 12/17/19
(SKU 94500976)
L
L
© Travis Industries, Inc.
Small holes indicate
location of tabs
L
#35
Advertisement
