WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service. 564 25K (Standard or CleanFace) Installation (for 564 SS units see page 5) NOTE On two-sided firebacks make sure to use the desired pattern.
Page 2
564 SS & 25K Fireback Installation 96100179, 96100187, 96100192, 96100270, 96100204 3. Rear Air Deflector (behind the rear log) Must be Removed (replace after firebacks in place) Remove the rear burner. NOTE: when replacing make sure the burner is properly aligned and the holes on the tabs on the burner insert over the pins IDB01282 on the burner stand.
Page 3
564 SS & 25K Fireback Installation 96100179, 96100187, 96100192, 96100270, 96100204 Media Tray Configuration Ceramic Firebacks (except for Ledgestone): The media tray is unchanged (the tabs on the side and back of the media tray remain bent out). The firebacks will rest on the bent out tabs of the media tray. The side and back firebacks rest on top of these tabs.
Page 4
564 SS & 25K Fireback Installation 96100179, 96100187, 96100192, 96100270, 96100204 Remove the clips on both sides (these clips have key-holes, Place the rear fireback in position. allowing removal without removing The side fireback holds the rear the screw) fireback in place – support the rear fireback while installing the side fireback.
Page 5
564 SS & 25K Fireback Installation 96100179, 96100187, 96100192, 96100270, 96100204 564 SS Installation (for 564 25K units see page 1) NOTE On two-sided firebacks make sure to use the desired pattern. 1. Remove the glass frame and logs (see the installation manual for details).
Page 6
564 SS & 25K Fireback Installation 96100179, 96100187, 96100192, 96100270, 96100204 3. Install the firebacks following the directions below. Remove the clip located on the firebox ceiling near the front (both sides). The side fireback clip has a keyhole slot. It can be removed Place the rear fireback in place.