Table of Contents
Advertisement
68
Optional Equipment
14 Stretch the included flex to its maximum length. Measure the distance between the starter collars
on the fireplace and the inlets on the convection manifold. Cut the flex to the appropriate length
and install between the fireplace and the manifold. Secure using (3) screws at every connection
and seal the joints with silicone caulk or aluminum (U.L. 181A-P) tape.
15 Cover the face of the fireplace and the outlet of the manifold to ensure no construction debris or
sheetrock dust enters the unit.
16 Once all finish work is complete around the outlet of the manifold, install the outlet grill assembly
using the two included screws (one at each end). The grill assembly will overlap finish material
up to 1-1/2" thick. See fireplace installation manual for finishing details.
NOTE: The manifold opening protrudes 7/16" proud of the framing. The wall may be finished to the
opening if you do not wish to use the grill trim.
© Travis Industries
(for qualified installers only)
5/8/2019 - 1505
Self-Drilling
Screw
564 GSR2 25K CF
Advertisement
Table of Contents
