Table of Contents
Advertisement
58
en | Cable and Wire Standards
5.3.2
Using a Fiber Optic Ethernet Media Converter to Transmit Video and
Control
The fiber optic media converter kit, available for AutoDome 700 Series cameras, is designed
to transmit 10/100 Mbps Ethernet signals over fiber optic cable using 10/100 Mbps Small
Form-factor Pluggable (SFP) modules. The SFP modules are available as multi-mode fiber
(MMF) or single-mode fiber (SMF) models with a single SC connector or dual-fiber with an LC
connector. Refer to the VG4-SFPSCKT Fiber Optic Media Converter Installation Guide.
Ethernet Media Converter
Data Interface
Data Rate
Fiber Type, MMF
Fiber Type, SMF
Maximum Distance
Requirement
Terminal Connection
5.4
Audio Cables
The VG5 700 Series AutoDome is capable of receiving line input audio signals and transmitting
it over a network. The audio signal is transmitted one-way and in sync with the video signals.
Audio Line Input Specifications
Max. Input Voltage
Impedance
Sample Rate
Shield
Internal gain level adjustment is available
Wire Specifications
Wire Type
Distance
Gage
Shield
Center conductor
NOTICE!
Separate the audio cables from the AC power lines to avoid noise.
F.01U.215.779 | 1.0 | 2011.07
Ethernet
10/100 Mbps
IEEE 802.3 Compliant
Full Duplex or Half Duplex Electrical Port
Full Duplex Optical Port
50/125 µm MMF. For 50/125 µm fiber, subtract 4 dB from the
specified optical budget value. Must meet or exceed fiber standard
ITU-T G.651.
8–10/125 µm SMF. Must meet or exceed fiber standard ITU-T
G.652.
60 km (37.3 miles)
Media converter receiver (CNFE2MC/IN) at controller end of
system
Duplex LC or Single SC
5.5 Vpp
9K Ω
8 K Hz, 16 Bit, mono
Bare copper braid: 95% coverage
3
Coax
(recommended)
10 m (33 ft)
22 AWG to Biphase connector (P105/P106)
Bare copper braid: 95% coverage
Stranded bare copper
Installation Manual
AutoDome 700 Series IP PTZ Camera
Bosch Security Systems, Inc.
Advertisement
Table of Contents
