Bosch AutoDome 700 Series Installation Manual page 27

AutoDome 700 Series IP PTZ Camera
9.
10. Connect the outgoing alarm wires to the flying leads coming from the 4-pin Alarm
11. Connect the incoming alarms wires to the flying leads coming from the 6-pin Alarm Inputs
12. Attach the 6-pin serial communication mating connector to the Serial Communication
13. Connect the Earth ground wire, if available, to the crimp ring terminal inside the
14. After making the harness connections to the Mounting Plate, rotate the Pendant Arm to
NOTICE! After all wiring is complete, close the cover door and tighten the two (2) captive
screws on the cover door to 10-12 N-m (90-105 in.-lbs).
Bosch Security Systems, Inc.
Connect the incoming RJ45 video connector, installed previously, to the UTP Video/
Ethernet cable (cable 5). Refer to Section 5 Cable and Wire Standards, page 57, for
detailed wire and connection information.
Outputs cable (cable 6).
cable (cable 7).
(cable 8) cable.
Mounting Plate. Refer to Figure 2.13 above.
Note: The Earth ground is not provided with the VG4-A-ARMPLATE kit; it is a ground
connection made at the installed location.
close and tighten the two (2) captive screws to 10-12 N-m (90-105 in.-lbs).
Installation Manual
Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts | en 27
F.01U.215.779 | 1.0 | 2011.07