Wire The Interface Box; Make The Connections - Bosch AutoDome 700 Series Installation Manual

AutoDome 700 Series IP PTZ Camera
5.
6.
4.6

Wire the Interface Box

The Interface Box can be wired through the top or side. Use the supplied rubber plug to seal
the hole which will not be used to route wires.
4.6.1

Make the Connections

After routing all video, control, power, and alarm wires:
1.
2.
3.
NOTICE!
If installing the dome to a drywall ceiling, allow enough wire to make the connections in the
Interface Box below the ceiling. Refer to , for connector locations and Table 4.1, Page 54, for
wire connections.
4.
Bosch Security Systems, Inc.
Tighten the four (4) securing screws to the Bracket Assembly.
Figure 4.4 Tighten Bracket Securing Screw
Secure the Bracket Assembly to an overhead securing point with a safety wire.
Figure 4.5 Secure Bracket Assembly
Attach a 3/4-inch NPS (20-mm) conduit fitting to the hole in which you bring in the wires.
Be sure to thread the inside nut to the conduit fitting.
Route the video, control, power, and alarm wires through the conduit fitting and into the
Interface Box.
Cut and trim the wires allowing for sufficient slack to their respective terminals in the
box.
Connect the Ethernet cable to its matting connector J101 in the Interface Box. Refer to
Section 5 Cable and Wire Standards, page 57 for specifications.
Installation Manual
Installing the In-Ceiling Mount | en
F.01U.215.779 | 1.0 | 2011.07
51