Vg4 Ip Autodome Video And Control - Bosch VG4-200 User Manual

76 en | Troubleshooting Guide
Inside of –
EnviroDome bubble If status reports Heater No Power, then:
is foggy –
–
If O.K., then:
–
Low Voltage flashing –
on monitor display
If O.K., then:
–
If O.K., then:
–
If O.K., then:
–
10.2

VG4 IP AutoDome Video and Control

Problem Solution
No Network –
Connection
If O.K., then:
–
F.01U.133.267 | 6.0 (IP4) | 2009.06
Check the status of the Heater Module (ON-66-ENTER).
Turn off the power to the AutDome.
Check the FX103 fuse in the Power Supply Box for power (24 V) to the heater module.
Check all wiring and connector pins to the heater module.
If using a non-Bosch power supply, confirm that it meets the Bosch AutoDome power
ratings. See the AutoDome Datasheet for specifications.
Check the mains input line voltage.
Check that the maximum wire length from the power supply has not been exceeded.
See the AutoDome Modular Camera System Installation Manual.
Measure the AC voltage input to the camera while power is applied to the camera. The
≥
voltage must be 21 VAC to stop the message.
Check all network connections
– Ensure that the maximum distance between any two Ethernet connections is 100
m (328 ft) or less.
Refer to the AutoDome Modular Camera System Installation Manual for more infor-
mation.
If you are behind a firewall, ensure that the Video Transmission mode is set to UDP.
a. Access the Settings Web page for the IP-enabled device.
b. Expand the Service Settings link, then click Network.
c. Select UDP from the Video Transmission drop-down list. Then click Set.
User's Manual
VG4 AutoDome Modular Camera System
Bosch Security Systems, Inc.