Table of Contents
Advertisement
36
en | Installing the Roof Parapet and Pipe Mounts
3.4.2
Wiring the Power Supply Box
1.
NOTICE!
The Power Supply Box with transformer comes with a barrier that separates the high voltage
side on the left from the low voltage 24 VAC side on the right.
2.
3.
4.
5.
NOTICE!
All video, control, and alarm wires either pass through the Power Supply Box or by-pass it and
connect directly to the Pipe Interface Board.
F.01U.215.779 | 1.0 | 2011.07
Route the high voltage 115/230 VAC lines through the conduit fitting on the left side of
the box.
Cut and trim the high voltage 115/230 VAC power and ground wires with sufficient slack
to reach their connector terminal in the box, but not so long as to be pinched by or to
obstruct closing the Cover Door. Refer to Section 3.1.1 Parts List, page 30, for connector
location.
Attach the supplied 3-pin Power Plug to the incoming high voltage power wires in the
box. Refer to connector P101 in Table 3.1, Page 38.
Route the Ethernet cable out to where the AutoDome will be mounted. Refer to
Section 5 Cable and Wire Standards, page 57 for specifications.
Route the low power 24 VAC wires from the right side of the Power Supply Box out to
where the AutoDome will be mounted. Attach the supplied 5-pin 24 VAC Dome plug to
the wire ends inside the box. Refer to connector P107 in Table 3.1, Page 38.
Installation Manual
AutoDome 700 Series IP PTZ Camera
Bosch Security Systems, Inc.
Advertisement
Table of Contents
