Table of Contents
Advertisement
20
en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts
WARNING!
Ensure that you connect the outgoing power supply wires to the P107 heater connectors (HN
and HL). The heater power (XF103) fuse can handle a higher amperage (3.15 A) than the
camera power (XF102) fuse (2.0 A).
6.
7.
8.
9.
F.01U.215.779 | 1.0 | 2011.07
Route the 24 VAC outgoing power supply wires into the VG4-PA0 power supply box
through the conduit fitting on the left side of the box.
Cut and trim the 24 VAC power and ground wires with sufficient slack to reach their
connector terminal in the box, but not so long as to be pinched by or to obstruct closing
the cover door.
Attach the supplied 3-pin power plug to the incoming 24 VAC power wires in the box, as
illustrated below.
P101
24V
NC
24V
1 2 3
GND TXD RXD
6 5 4 3 2 1
6 5
6 5
5
5
5 4
5
Figure 2.8 VG4-PA0 Power Supply Box
1 Incoming 24 VAC Power Supply Wires (from VG4-PSU1/VG4-PSU2 power supply box)
2 Ground Wire
3 P101 Connector
4 Control Data and Video In/Out Wires
Follow the instructions in Section 2.6 Attach Pendant Arm to Power Supply Box, page 21, to
continue the installation.
Installation Manual
J102
(LED)
P106
P105
C+ C-
GND TXD RXD
C+ C-
4
4 3 2 1
4
4
4
4
6 5 4 3 3
6 5 4 3 2 1
3
2 1
AutoDome 700 Series IP PTZ Camera
Bosch Security Systems, Inc.
Advertisement
Table of Contents
