Connecting Wires To The Pipe Interface Board - Bosch AutoDome 700 Series Installation Manual

AutoDome 700 Series IP PTZ Camera
Ref. Description
1
2
3
4
5
6
7
8
9
10
11
12
3.7.1

Connecting Wires to the Pipe Interface Board

The Pipe Interface Board contains all of the connectors for control, data, image, and power
wires. Follow the procedures below to make the proper connections.
WARNING!
Use a 24 VAC Class 2 power supply only.
1.
WARNING!
Do not connect the RJ45 connector unless using UTP video or Ethernet. This connection
causes video distortion.
2.
3.
CAUTION!
To protect the AutoDome from damage due to cold temperatures, ensure that you connect the
24 VAC heater power wires to the P101 connector.
Bosch Security Systems, Inc.
Pipe Interface Module
Video Coax In
6-pin Connector Alarms In (3-7)
4-pin Connector Alarms Out (1-3)
100 Ω Resistor
Data In/Out
Alarms In (EOLR Supervised, 1-2)
Relay Output
Dome Power
Heater Power
RJ45 Ethernet or UTP Video
(Ethernet for VG5 700 Series only)
To AutoDome
Attach an RJ45 connector plug to the Ethernet cable and connect the plug to its mating
connector J101 on the Pipe Interface Board.
Attach the control data in/out wires to their respective terminals on the P105 connector
on the Pipe Interface Board. Refer to Figure 3.10, Page 42, for an illustration of these
connections.
Connect the 24 VAC power wires to the P101 connector on the Pipe Interface Board. If
this model has a heater, connect the 24 VAC heater power wires to connector P107.
Installation Manual
Installing the Roof Parapet and Pipe Mounts | en
Connector Wire Gauge
J102
P103
P102
P105
P105 AWG 26-16
P104 AWG 26-16
P104 AWG 26-16
P101 AWG 18-14
P107 AWG 18-14
J101
43
Pin Description
1 Biphase (C-)
2 Biphase (C+)
3 Earth Ground
4 RxD +
5 TxD -
6 Signal Ground
7 Ground
6 Alarm 2
5 Alarm 1
4 Earth Ground
3 Normally Closed
2 Common
1 Normally Open
3 Dome 24 VAC
2 Earth Ground
1 Dome 24 VAC
2 Heater 24 VAC
1 Heater 24 VAC
F.01U.215.779 | 1.0 | 2011.07