Table of Contents
Advertisement
18
en | Preparing the Wiring
4
Preparing the Wiring
There are three (3) types of wires required: ethernet, power,
and alarm. Each section provides the specifications for the
recommended wire.
CAUTION! Installation should only be performed by qualified
!
service personnel in accordance with the National Electrical
Code or applicable local codes.
4.1
Ethernet (Control and Video)
The AutoDome Easy IP is connected to a 10 Base-T/100 Base-TX
network either directly or via a hub. Both video and control are
transmitted over a standard IP network using the built-in web
server.
Cable type
Maximum distance
Bandwidth
Terminal connector
Ethernet connections
The AutoDome Easy IP contains a CAT-5E Ethernet cable
terminated with an RJ45 female connector.
4.2
Power
The recommended power cable is a 2-conductor, 14-18 gage
cable, depending on the distance. Refer to the wiring distance
guide below.
24 VAC input 24 VA / 12 W 949 ft
12 VDC input 12 W
Power connections
Follow the instructions in the table below to terminate the two
(2) power connections:
F01U079609 | 1.0 | 2008.08
CAT-5E or CAT 6 Ethernet
100 m (328 ft)
10 Base-T/100 Base-TX
RJ45
VA / Watts
14 AWG
(2.5 mm)
(289 m)
237 ft
(72 m)
Installation Manual
AutoDome Easy IP
16 AWG
18 AWG
(1.5 mm)
(1.0 mm)
597 ft
376 ft
(182 m)
(115 m)
149 ft
94 ft
(45 m)
(29 m)
Bosch Security Systems, Inc.
Advertisement
Table of Contents
