Table of Contents
Advertisement
[Setup via recorder's main monitor]
On: Uses the SD memory backup function.
Off: Does not use the SD memory backup function.
Default: Off
SD backup rec.
The SD memory backup is a function to save images
on the SD memory card inserted in the camera when
the recorder fails to communicate with the camera
during the set recording time.
The SD memory backup is only available if the cam-
era supports the SD memory recording and the com-
pression is set to H.264/H.265.
The SD memory recording is done by the registered
compression of the camera.
Note:
• If the camera is set to "Not use" the SD memory
card or the SD memory card is not inserted
(including insufficient insertion), error messages
are displayed some times in a day and recording
is paused for about 20 seconds.
• If the SD backup rec. function is used, set the
operation mode of the SD memory card to
"Overwrite On" from the camera side.
Acquire the image saved on the SD memory card
Acquire the image saved on the SD memory card to
the recorder and record it to the HDD.
Acquisition of images from the SD memory card is
automatically done a quarter past every hour.
(0:15, 1:15, ∙∙∙23:15)
You can check whether the recorder is acquiring the
SD memory data on the "Status display area".
Important:
• When the recording starting time set on the sched-
ule has arrived without communication between
the camera and the recorder, the SD memory
backup will not be executed.
• Do not set the SD memory backup function to the
same camera from multiple network disk recorders.
• The recording time of the acquired SD memory
data will be time of the camera. Adjust time of the
camera and the recorder using the NTP function
and the camera time auto synchronization func-
tion. If time is not adjusted, the SD memory
backup may not be available.
Note:
• All images may not be acquired at one time due to
the time between time tables of the schedule and
the total capacity of the images. The remaining
images will be acquired at the subsequent acqui-
sition time.
• The image is not acquired during the following
cases. Playing the image/HTTP downloading/
Emergency recording/External recording
• If the following operations occur during acquiring
the SD memory data, the acquisition is paused.
Communication failure with the camera while
acquiring SD memory data /Entering in HDD man-
agement page of [Advanced setup]/Power failure
detection signal enters this unit
[Smart coding (GOP control)]
Select when you use the smart coding (GOP control)
function of the camera.
On (Advanced): Uses the smart coding.
Off: Does not use the smart coding.
Refer to "readme.txt" for model numbers and version
information of cameras that have the smart coding
(GOP control) function.
45
Advertisement
Table of Contents
