Table of Contents
Advertisement
[Setup via recorder's main monitor]
Set up camera site alarm [Advanced camera site alarm setup]
Set up the action to be taken when a Panasonic alarm protocol received from a camera triggers camera site
alarm.
Refer to the "Set up terminal alarm [Advanced terminal alarm setup]" section (☞ Page 42) for further informa-
tion about the items available for "Advanced camera site alarm setup"; "Mode" and "Alarm log", and also
"Recording camera", "Preset" and "Terminal output" under "Setup by camera".
[Back] button
Click the button after completing the settings. The
screen returns to the [Event setup] tab.
Note:
• If the event recording time (☞ Page 36) is
shorter than alarm deactivation time set from the
camera, the event recording may not be done for
alarms which continuously occur.
Set up command alarm [Advanced command alarm setup]
Set up the action to be taken when a command alarm signal received from a PC that is connected via a net-
work protocol triggers command alarm.
Refer to the "Set up terminal alarm [Advanced terminal alarm setup]" section (☞ Page 42) for further informa-
tion about the items available for "Advanced command alarm setup"; "Mode" and "Alarm log", and also
"Recording camera", "Preset" and "Terminal output" under "Setup by command number".
[Back] button
Click the button after completing the settings. The
screen returns to the [Event setup] tab.
43
Advertisement
Table of Contents
