Table of Contents
Advertisement
[Operation via recorder's main monitor]
Cancel the alarm action
The recorder will take an alarm action according to the settings configured in advance when an event occurs in
the alarm mode (ALM). Information of the occurred alarm will be displayed on the status display panel of the
main monitor. (☞ Page 102) To reset the alarm action, click the [Alarm] button on the status display panel, and
click the alarm [Reset] button.
When an item other than "Ext." is selected for "Auto reset time" on the "Event setup" tab under "REC & event"
on the setup menu [Basic setup] (☞ Page 40), the following actions will automatically be taken even if the
alarm action is not canceled by clicking the alarm [Reset] button.
• The alarm indicator on the front panel will stop blinking and light steadily.
• The alarm status display on the main monitor will disappear.
• The sounding buzzer and the alarm output will stop.
Step 1
Click the [Alarm] button displayed on the main moni-
tor, and click the alarm [Reset] button.
→ The alarm action will be canceled and the alarm
→
indicator will go off.
Cancel the error action
When an error (trouble) occurred on the recorder, the recorder will take the error action (a series of actions that
notifies of the error occurrence). Information of the occurred error will be displayed on the status display panel
of the main monitor. (☞ Page 102) To cancel an error action, first click the [Error] button on the status display
panel and then the displayed error [Reset] button.
Note:
• When an error occurs, take remedial action by following the instructions displayed on the error log panel
(☞ Page 141). The error indicator on the front of the recorder will keep blinking till the cause of the error is
eliminated.
• When the cause of the error is resolved automatically, the following operations are performed automatically.
• The error indicator on the front panel will stop blinking and light steadily.
• The error status display on the main monitor will disappear.
• The sounding buzzer and error output will stop.
• Clicking the error reset button turns off the error button and error indicator.
• Press [LCD SW] button of the recorder to turn off the error display of the LCD on the front side of the
recorder.
Note:
• When the alarm action is canceled, the event
recording will stop and return to the operational
status just before the event occurred.
129
Advertisement
Table of Contents
