Table of Contents
Advertisement
[Operation via recorder's main monitor]
Record images
Live images can be recorded on the recorder. The image of up to 128 cameras can be recorded in the recorder.
Record images (Schedule recording)
Recording can be automatically started and stopped according to a previously specified schedule. Refer to
page 35 for schedule recording.
Note:
• When event recording is triggered by an alarm during the schedule recording, event recording has the
higher priority. Refer to the "Recording mode and its priority" section below for further information about the
priority of the recording mode.
• To stop schedule recording, stop the recording on the setup menu. Refer to page 44 for further information.
• In case of a network error, the image of the camera where the communication error has occurred will not be
recorded. Recording starts when the network error is recovered. If the status in which the communication
with the camera is disconnected recovers within around 40 seconds, it may not be recorded in the error log.
• Schedule-recorded image data will be divided into multiple files every hour on the hour. In that moment,
recording may sometimes be interrupted around for 1 second.
Recording mode and its priority
There are 4 recording modes. The recording modes and their priority levels are as follows.
When two or more recordings with different recording modes started simultaneously, only recording with the
higher priority will start.
Recording mode
Emergency recording
Event recording
Schedule recording
Pre-event recording
Audio
The audio recording is done at the same time as the image recording. The audio recording can be set for each
camera. Refer to page 38 for further information.
Note:
• The audio recording is done at the same time as the image recording. Recording of the audio only is not
available.
Network cameras
Priority
1
2
3
4
130
Image data
HDD
Recorder
Advertisement
Table of Contents
