Table of Contents
Advertisement
About license registration
Register the license of the NAS backup function to use it. To register the options, the "Registration Key" that
can be obtained from the Key Management System is required. Refer to the "Activation Key Card" attached to
the recorder for how to obtain the registration key.
Enter the following number for the Activation Key No. and the registration ID.
Activation Key No.: 1572-0060-030B-1234
Registration ID: 25D2-36AB
Refer to [Registration of license] (☞ Page 68) for license registration of the NAS backup function.
Configure the Settings of the NAS backup function
Important:
• When the setting of the NAS backup function is changed, the backup processing will stop. If the setting is
changed during the backup, the backup schedule will not be executed until the next backup time.
This also applies to the case of the HDD management screen being displayed.
Click the [Extra function] - the [NAS backup] tab of the [Advanced setup] on the setting menu.
→ The NAS backup screen will be displayed.
→
[NAS backup]
On: Enables the NAS backup function.
Off: Disables the NAS backup function.
[Selection of storage destination]
Check the storage destination used for backup. When two storage destinations are set, the backup will be writ-
ten to the other storage destination once the remaining capacity of the initial storage destination during backup
runs out.
Storage-1/Storage-2
[IP address]
Set the IP address of the NAS.
[Directory name]
Set the storage destination directory name. (☞ Page 205)
206
Advertisement
Table of Contents
