Table of Contents
Advertisement
[Operation via recorder's main monitor]
[Position]
Registers the current orientation of the camera as a
preset position. Moves the camera to a previously
registered preset position.
When the page is switched to 2/2 with a button on the
top right of the detailed control panel, the following
camera operation can be performed.
[AUX] button
Sets the device connected to the AUX terminal of the
camera to the open/closed state.
If the camera is a network camera, AUX1, 2 and 3 is
controlled with only AUX1 of the camera.
If the device is the encoder GXE500, the AUX1 and 2
control terminals of a camera or a receiver (WV-
RC150) are applicable for each analogue camera
connected to it.
The AUX3 controls the AUX output terminal (1 system
only) of GXE500.
[Wiper] button
Operates the washer/wiper of the WV-SUD638.
[Setup] button
Displays the camera setup window for registering a
home position (☞ Page 124), executing auto back
focus (☞ Page 124), etc.
[Back] button
Closes the "Camera control [Advanced]" and returns
to the camera control panel.
Note:
• Controlling the cameras is not possible on the
wide view screen and on the 9-Screen/16-screen.
118
Advertisement
Table of Contents
