Combustion Blower - England's Stove Works 55-TRPCB120 Installation & Operation Manual

Combustion Blower
 Before beginning any component replacement, be certain the unit is unplugged and
thoroughly cooled down.
 Remove the left side panel and locate the combustion blower.
 Disconnect the venting system from the exhaust blower, and disconnect the exhaust
blower from the stove wiring harness. To remove the venting pipe, removal of the rear
5
panel (using a
 Remove all (5) screws which hold the exhaust blower to the exhaust blower tube. Remove
the heat sensor which is connected (with a screw) to the exhaust blower. Once the screws
have been removed, the blower can be lifted up and out of the stove.
 Reinstallation is the exact opposite of the steps above; however, be certain to check the
condition of the exhaust blower gasket and replace if necessary.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
REPLACING COMPONENTS
/ " wrench) may be necessary.
16
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
42