England's Stove Works 55-TRPCB120 Installation & Operation Manual page 37

that has built up on the fan blades can usually be easily removed with a vacuum or a soft paint brush. Remove
5
(4) / " screws that hold the bracket in place to remove the blower.
16
Cleaning Pellet Fines from the Hopper and Auger
Depending on the type and quality of pellets burned in the stove, some accumulation of pellet fines and
dust is possible in the hopper. The lowest part of the auger, near the back of the stove, is where most fines
will accumulate. With the stove off, unplugged, completely cool and with the hopper empty, use a utility
vacuum to remove the fines from the auger tube. If the fines cannot be removed from the top of the hopper:
 Remove the back panel, using a
 Locate the auger motor assembly at the middle rear of the stove, and once it is found, find the
two set screws on either side of the cast iron mounting collar.
 Using a
1
/ " allen wrench, loosen the set screw on either side of the auger mounting collar.
8
 With a utility vacuum in hand, let the auger assembly slide out of the auger tube just enough
so that the vacuum can be used to remove any fines from this area.
 Reinstall the auger assembly and tighten the two set screws; reinstall the back panel, being
certain to tighten the retaining screws on the rear of the stove.
Cleaning Pellet Fines Inside Auger Tube
 Remove the auger cover plate (located above the auger at the bottom of the hopper) by
removing the (8) 5/16" screws that hold it in place. Using a utility vacuum remove any excess
dust or fines that have collected in the auger tube around the auger.
 Re‐install auger cover plate in reverse method.
Checking Gaskets
An airtight seal at the door opening is crucial to proper stove performance. Any air leaks in this area can
not only cause a dirty, inefficient burn but can also pose a serious safety threat. Because of this, the door
gasket should always be maintained in good condition, and replaced annually or sooner if necessary. Gasket
tightness can be checked using the "dollar‐bill" method:
 Place a dollar bill between the gasket and the stove body (at the location where the gasket
meets the stove).
 Close the door tightly and attempt to pull the dollar bill out. If the dollar bill slides in and out
easily, the gasket needs to be replaced. This test should be repeated around the entire gasket
perimeter, as gaskets will sometimes seal tightly on one side, but will be worn and seal poorly
on another side.
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
YEARLY MAINTENANCE
5
/ " socket to remove the screws.
16
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
37