Starting An Api Session Via An Rs-232 Interface - Polycom VSX3000 Integrator's Reference Manual

Starting an API Session via an RS-232 Interface

After you have verified that the VSX system and your computer are both
configured appropriately, set up both devices as follows:
1. Power off the computer and the VSX system.
2. Use an RS-232 cable to connect the control system or computer RS-232
port to the RS-232 port on the VSX system as shown in the following
illustration.
VSX 6000 or VSX 7000
RS-232 port
VGA
3
VSX 6000A or VSX 7000s
RS-232 port
24V
VSX 7000e or VSX 8000
3. Power on the computer and the VSX system.
4. From the computer, start a serial session using HyperTerminal or another
appropriate utility.
If the VSX system has Security Mode enabled, you must use a utility that
supports Transport Layer Security (TLS), and you must provide the
remote access password.
0101
2
2
1
LAN
2
101010
VGA
3A 1
LAN
IR
3
1
VCR/DVD
IOIOIO
1 2
Using the API
90-250VAC 50/60Hz 4A
PC CARD
2 VGA
2
VGA
LAN
RS-232 ports
3 - 3