Rts - Polycom VSX3000 Integrator's Reference Manual

rts

Sets or gets the RTS serial interface control signal (request to send). This
command is only applicable if you have a V.35 network interface connected to
your system.
Syntax
rts <get|normal|inverted>
Parameter
get
normal
inverted
Feedback Examples
• rts normal
• rts inverted
Comments
The default setting is
User interface screen location: System > Admin Settings > Network >
V.35/RS-449/RS-530 (page 3): RTS
Description
Returns the current setting.
Sets the signal to normal (high voltage is logic 1).
Sets the signal to inverted (low voltage is logic 1).
.
"normal"
System Commands
4 - 227