Pricallbycall - Polycom VSX3000 Integrator's Reference Manual

Integrator's Reference Manual for the VSX Series

pricallbycall

4 - 198
Sets or gets the PRI call-by-call value. This command is only applicable if you
have a PRI network interface connected to your system.
Syntax
pricallbycall get
pricallbycall set {0..31}
Parameter
get
set
{0..31}
Feedback Examples
pricallbycall set 1
returns
pricallbycall 1
Comments
Call-by-call is a number from 0 to 31, which is optionally sent to an upstream
telephone company switch, if required. For example, specify a value of 6 for a
T1 PRI network interface module that is directly connected to an ATT 5ESS
switch, which is provisioned with Accunet. You must consult with the
telephone company service provider to determine whether a call-by-call value
is required for a particular PRI line. For most cases, the default value of 0 is
correct. Always use the value 0 when connected to a PBX. A non-zero value
should not be required in Europe. Values greater than 31 are reserved for
internal use and must not be used.
User interface screen location: System > Admin Settings > Network > ISDN
(page 3): Call-by-Call
This screen is only accessible if you have a PRI network interface connected to
your system.
Description
Returns the current setting.
Sets PRI call-by-call when followed by a value from
{0..31}.
Range of call-by-call values.