Flue Connection; Electrical Connection - Vulcan-Hart VFRY Series Installation And Operational Manual

VK / TR / VFRY SERIES GAS FRYERS
Make the flue connection as follows:

Comply with Vapor Removal from Cooking Equipment, ANSI-NFPA
Standard #96 (latest edition), available from the National Fire Protection
Association, Batterymarch Park, Quincy, MA 02269.

Locate the fryer under a hood with adequate connection to an exhaust
duct. The hood must extend 6" (15 cm) beyond fryer on both sides.

Clearance above the fryer should be adequate for combustion byproducts
to be removed efficiently.
 An 18" (46 cm) minimum clearance should be maintained between the flue
vent and the filters of the hood venting system.

Never make flue connections directly to the fryer.

Do not obstruct the flow of the gases from the appliance. Proper air
balance should be maintained in the room.
 Ensure that your ventilation system does not cause a down draft at the fryer's flue
opening. Down drafts will not allow the fryer to exhaust properly and will cause
overheating which may cause permanent damage. Damage caused by down drafts
will not be covered under equipment warranty. NEVER allow anything to obstruct
the flue of combustibles or ventilation exiting from the fryer flue. DO NOT put
anything on top of flue area.
This appliance is equipped with a three prong (grounding) plug for your protection
against shock hazard and should be plugged directly into a properly grounded
three-prong receptacle. Do not cut or remove the grounding prong from this plug.
Fryer must be electrically grounded in accordance with local codes, or in the
absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the
Canadian Electrical Code, CSA C22.2, as applicable.
Electrical diagram located on inside of door.
VULCAN

FLUE CONNECTION

ELECTRICAL CONNECTION

Electrical Grounding Instructions:
F-32971 Rev.U (12-17)