Installing the speakers
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the speakers and provides a visual representation of the installation procedure.
Steps
1. Align and place the speaker module into its slot on the top edge of the palm rest.
2. Route the speaker cable using the routing threads on the inner frame.
3. Connect the speaker cable to its connector on the system board.
Next steps
1. Install the battery.
2. Install the
secondary solid-state
3. Install the
primary solid-state
4. Install the
base
cover.
5. Follow the procedure in
Inner frame
Removing the inner frame
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
primary solid-state
4. Remove the
secondary solid-state
5. Remove the battery.
6. Remove the
long CAMM
drive.
drive.
after working inside your
before working inside your
drive.
drive.
module.
computer.
computer.
Removing and installing components
59