Installing The Power-Adapter Port - Dell Precision 7680 Service Manual

5. Remove the CAMM module
6. Remove the interposer board
7. Remove the primary solid-state
8. Remove the secondary solid-state
9. Remove the heat-sink for integrated graphics
10. Remove the inner frame.
11. Remove the system board.
About this task
The figure indicates the location of the power-adapter port and provides a visual representation of the removal procedure.
Steps
1. Remove the (M2x3) screw that secures power-adapter port bracket.
2. Disconnect the power-adapter cable from the connector on the system board.
3. Remove the power-adapter port bracket from the computer.
4. Unroute the power-adapter cable from the routing guide on the computer chassis.

Installing the power-adapter port

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the power-adapter port and provides a visual representation of the installation procedure.
78 Removing and installing components
or long CAMM module or
module.
drive.
drive.
or heat-sink for discrete
memory module.
graphics.