Table of Contents
Advertisement
Installing the speakers for mainstream
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speakers and provides a visual representation of the installation procedure.
Figure 26. Installing the speakers for mainstream
Steps
1. Using the alignment posts and rubber grommets, place the speakers into the slots on the palm-rest and keyboard assembly.
NOTE:
To properly position the speakers, secure the rubber grommets into the hooks.
2. Route the speaker cable along the bottom side of the palm-rest and keyboard assembly. Then secure the speaker cable into
the routing guides on the palm-rest and keyboard assembly.
3. Connect the speaker cable to the connector on the system board.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in
CAUTION:
Removing the coin-cell battery resets the BIOS setup program's settings to default. It is
recommended that you note the BIOS setup program's settings before removing the coin-cell battery.
58
Removing and installing Customer Replaceable Units (CRUs)
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
