2. Remove the fuel cap by rotating it counterclockwise.
Fuel Filler Cap
3. Fully insert the gasoline nozzle into the filler pipe.
Fill the vehicle with fuel.
4. When the fuel nozzle "clicks" or shuts off, the fuel
tank is full. Wait five seconds before removing the
fuel nozzle to allow excess fuel to drain from nozzle.
5. Remove gasoline nozzle, reinstall fuel cap and close
the fuel filler door.
WARNING!
•
Never have any smoking materials lit in or near the
vehicle when the fuel door is open or the tank is
being filled.
•
Never add fuel when the engine is running. This is
in violation of most state and federal fire regula-
tions and may cause the Malfunction Indicator
Light (MIL) to turn on.
•
A fire may result if fuel is pumped into a portable
container that is inside of a vehicle. You could be
burned. Always place fuel containers on the
ground while filling.
CAUTION!
•
Damage to the fuel system or emission control
system could result from using an improper fuel
filler cap. A poorly fitting cap could let impurities
into the fuel system. Also, a poorly fitting aftermar-
ket cap can cause the Malfunction Indicator Light
(MIL) to illuminate, due to fuel vapors escaping
from the system.
•
To avoid fuel spillage and overfilling, do not "top
off" the fuel tank after filling.
NOTE:
•
When the fuel nozzle "clicks" or shuts off, the fuel
tank is full.
•
Tighten the fuel filler cap about a quarter turn until
you hear one click. This is an indication that the cap
is properly tightened.
•
If the fuel filler cap is not tightened properly, the MIL
will come on. Be sure the cap is tightened every
time the vehicle is refueled.
LOOSE FUEL FILLER CAP MESSAGE
After fuel has been added, the vehicle diagnostic sys-
tem can determine if the fuel filler cap is possibly loose,
improperly installed, or damaged. If the system detects
a malfunction, the "gASCAP" message will display in the
odometer display. Tighten the gas cap until a "clicking"
sound is heard. This is an indication that the gas cap is
properly tightened. Push the odometer reset button to
turn the message off. If the problem persists, the mes-
sage will appear the next time the vehicle is started.
STARTING AND OPERATING
This might indicate a damaged cap. If the problem is
detected twice in a row, the system will turn on the MIL.
Resolving the problem will turn the MIL off.
VEHICLE LOADING
CERTIFICATION LABEL
As required by National Highway Traffic Safety Adminis-
tration regulations, your vehicle has a certification label
affixed to the driver's side door or B-pillar.
This label contains the month and year of manufacture,
Gross Vehicle Weight Rating (GVWR), front and rear
Gross Axle Weight Rating (GAWR), and Vehicle Identifi-
cation Number (VIN). A Month-Day-Hour (MDH) number
is included on this label and indicates the Month, Day
and Hour of manufacture. The bar code that appears
on the bottom of the label is your VIN.
Gross Vehicle Weight Rating (GVWR)
The GVWR is the total permissible weight of your vehicle
including driver, passengers, vehicle, options and cargo.
The label also specifies maximum capacities of front
and rear GAWR. Total load must be limited so GVWR
and front and rear GAWR are not exceeded.
Payload
The payload of a vehicle is defined as the allowable
load weight a truck can carry, including the weight of
the driver, all passengers, options and cargo.
151
4