Permanent Power Limitation - Daikin ERLA11D V3 Series Installer's Reference Manual

6 | Application guidelines

6.6.1 Permanent power limitation

Installer reference guide
58
#
3 "6.6.4 BBR16 power
▪ Restriction: Only available in Swedish language.
▪ Allows you to comply with BBR16 regulations (Swedish energy
regulations).
▪ Limitation of power in kW.
▪ Can be combined with the other kW power consumption controls. If you
do so, the unit uses the most restrictive control.
4 "6.6.5 Smart Grid capacity limitation due to
▪ Restriction: Only available if a Smart Grid is installed and Recommended
on mode is active.
▪ Allows you to limit the power consumption of the entire heat pump
system (sum of outdoor unit and backup heater or booster heater (if
electrical heaters are allowed for buffering)) with a pulse meter or by
using setting [9.8.8] Limit setting kW.
▪ Limitation of power in kW.
NOTICE
It is possible to install a field fuse with lower than recommended rating over the heat
pump. For this you must modify field setting [2‑0E] according to the maximum
allowed current over the heat pump.
Note that field setting [2‑0E] overrules all power consumption control settings.
Power limiting the heat pump will reduce performance.
NOTICE
Set a minimum power consumption of ±3.6 kW to guarantee:
▪
Defrost operation. Otherwise, if defrosting is interrupted several times, the heat
exchanger will freeze up.
▪
Space heating and DHW production by allowing the backup heater step 1.
▪
Anti-legionella operation.
Permanent power limitation is useful to assure a maximum power or current input
of the system. In some countries, legislation limits the maximum power
consumption for space heating and DHW production.
P
i
a
DI
P Power input
i
t Time
DI Digital input (power limitation level)
a Power limitation active
b Actual power input
Setup and configuration
▪ No additional equipment needed.
Power consumption control
4
limitation" [ 61]
b
t
4
buffering" [ 61]
ERLA11~16D + EBVH/X11+16S18+23D
Daikin Altherma 3 R F
4P643602-1B – 2022.05