Tcp/Ip Interface Object (Class Id: F5 Hex) - Omron sysmac NX102-9 Series Owner's Manual

8 CIP Message Communications
8-5-4

TCP/IP Interface Object (Class ID: F5 hex)

This object is used to read and write settings such as the IP address, subnet mask, and default gate-
way. For an NX701 CPU Unit and an NX102 CPU Unit, it is necessary to use the route path of the CIP
communications command (the RoutePath in-out variable) to specify the port number (1 or 2) of the
built-in EtherNet/IP port to access.
Service Codes
Specify the service to execute with the service code.
Service
Parameter name
code
01 hex Get_Attribute_All
0E hex Get_Attribute_Single
10 hex Set_Attribute_Single
Class ID
Specify F5 hex.
Instance ID
Specify 00 or 01 hex.
00: Specify the class
01: Built-in EtherNet/IP port
Attribute ID
The attribute ID specifies the information to read.
 Class Attribute ID
The class attribute ID specifies the attribute of the entire object.
Attribute ID Parameter name
01 hex Revision
02 hex Max Instance
03 hex Number of Instances
8-72
Description
Reads the values of the attributes.
Reads the value of the specified attribute.
Writes a value to the specified attribute. The built-in EtherNet/IP port
restarts automatically after the value is written to the attribute. When
the restart process is not completed and the next Set_Attribute_Single
is executed, the general status "0C hex" (Object State Conflict) is
returned.
Description
Revision of the object
The maximum instance number
The number of object instances
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User's Manual (W506)
Read data
Attribute
Data
type
Read UINT 0001 hex: Unit version 1.01 or earlier
0002 hex: Unit version 1.02 to 1.09
0003 hex: Unit version 1.10
0004 hex: Unit version 1.11 or later
Read UINT 0001 hex
Read UINT 0001 hex
Supported services
Classes Instances
Sup- Not sup-
ported. ported.
Sup- Sup-
ported. ported.
Not sup- Sup-
ported. ported.
Value