Omron sysmac NX102-9 Series Owner's Manual page 317

Parameter name
Event occurred time
Product code
Event code
Additional information[0]
to
Additional information[31]
 CIP Error Codes
General
status
code (hex)
02
0C
13
15
1F
20
 Method of Use
1
The following variables are generated and initialized to 0.
Total number of readout records (UINT)
Previous error update count (UINT)
2
Specify the following parameters and execute Get current error (3A hex).
• Unit No: Unit number subject to error information read
• Start number of read record: 0
• Number of read record: Number of read records
3
The following parameters are read from the response data.
• Error update count
• Number of registered record
• Number of readout record
• Current error record
When the first response is obtained, the value of Error update count is retained as the previous
error update count.
When the second response onwards is obtained, the previous error update count and the Error
update count are compared. If the value was changed, execute from step 1 again since the cur-
rent error of the Unit was added.
4
Add the Number of readout record value of the response data to the total number of readout
records.
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User's Manual (W506)
UDINT
UDINT
UDINT
Array of BYTE
Error name
Resource unavailable
Object state conflict
Not enough data
Too much data
Vendor specific error
Invalid parameter
8 CIP Message Communications
Data type
Error occurred time
Product code of the Unit in which errors occurred
Event code
Attached information (system information) of
event.
Resources needed for the object to perform the requested
service were unavailable.
The object cannot perform the requested service in its cur-
rent mode/state.
Data required for the execution of the required service is
insufficient.
Extra data for the execution of the required service is
included.
The service could not be executed due to internal reasons.
• The Unit number is out of the supported range.
• The specification of the number of readout records is out
of the range.
• The Unit does not exist.
Description
Cause
8
8-61