Omron sysmac NX102-9 Series Owner's Manual page 496

Appendices
Acceptable System Configuration Conditions for Setting the
EtherNet/IP Connection Settings on the Sysmac Studio
If an NJ/NX-series Controller operates as the originator device, you can use the Sysmac Studio to set
the originator device settings for the EtherNet/IP connections.
Similarly, if an NJ/NX-series Controller operates as the target device, you can use the Sysmac Studio to
set the tags and tag sets of the target device.
Settings for the originator device
NX-series Controller
(Two built-in
EtherNet/IP ports)
NJ-series Controller
(CPU Unit built-in
EtherNet/IP port or
EtherNet/IP Unit)
Tag and tag set settings
Setting with the Sysmac
Studio is possible.
Use the Network Configurator if a CS-/CJ-series PLC operates as the originator device.
Settings for the originator device
CS-/CJ-series PLC
Setting only with
the Network Configurator is possible.
A-6
Settings for the target device
NX-series Controller
(Two built-in
EtherNet/IP ports)
NJ-series Controller
(CPU Unit built-in EtherNet/IP port
or EtherNet/IP Unit)
CS-/CJ-series PLC
FH/FZ/FQ/ZW-series Sensor
or another similar unit
Connection settings
Setting with the Sysmac
Studio is possible.
Settings for the target device
NJ/NX-series Controller
NJ/NX-series CPU Unit Built-in EtherNet/IP Port User's Manual (W506)
Tag and tag set settings
Setting with the Sysmac
Studio is possible.
Tag and tag set settings
Setting only with the Network
Configurator is possible.
Tag and tag set settings
Settings not required.